Pioneer DEH-P6400R - Manual (Page 32)

Audio Adjustments
Using balance adjustment
You can select a fader/balance setting that pro-
vides an ideal listening environment in all occu-
pied seats.
1 Press AUDIO to select Fad .
Press AUDIO until Fad appears in the display.
• If the balance setting has been previously
adjusted,
Bal will be displayed.
2 Press
5 or ∞ to adjust front/rear speaker
balance.
Each press of
5 or ∞ moves the front/rear
speaker balance towards the front or the rear.
•
Fad F15 – Fad R15 is displayed as the front/rear
speaker balance moves from front to rear.
•
Fad 0 is the proper setting when only two
speakers are used.
• When the rear output setting is
FRT+SW , you
cannot adjust front/rear speaker balance. Refer
to Switching the rear output setting on page 38.
3 Press
2 or 3 to adjust left/right speaker
balance.
When you press
2 or 3,
Bal 0 is displayed. Each
press of
2 or 3 moves the left/right speaker
balance towards the left or the right.
•
Bal L9 – Bal R9 is displayed as the left/right
speaker balance moves from left to right.
Using the equalizer
The graphic equalizer lets you adjust the equal-
ization to match car interior acoustic character-
istics as desired.
Recalling equalizer curves
There are seven stored equalizer curves which
you can easily recall at any time. Here is a list of
the equalizer curves:
Display Equalizer curve
SUPER BASS Super bass
POWERFUL Powerful
NATURAL Natural
VOCAL Vocal
CUSTOM1,2 Custom1,2
FLAT Flat
• CUSTOM1 and CUSTOM2 are adjusted equal-
izer curves.
• A separate
CUSTOM1 curve can be created
for each source. (The Built-in CD player and
Multi-CD player are set to the same Equalizer
Curve Adjustment setting automatically.)
• If you make adjustments when a curve other
than
CUSTOM2 is selected, the equalizer curve
settings are memorized in CUSTOM1 .
• A CUSTOM2 curve can be created common to
all sources.
• If you make adjustments when the
CUSTOM2
curve is selected, the CUSTOM2 curve is
updated.
• When
FLAT is selected no supplement or
correction is made to the sound. This is useful
to check the effect of the equalizer curves by
switching alternatively between
FLAT and a set
equalizer curve.
En 32
07
Section