Brother MFC-8870DW - Manual (Page 30)

Installing the Driver & Software
28
STEP 2
Windows
®
W
ind
ow
s
®
Wi
re
le
ss
Netw
o
rk
2
Plug in the power cord and turn on the
machine.
Improper Setup
If you have previously configured the wireless
settings of the machine you must reset the
network (LAN) settings before you can
configure the wireless settings again.
Press Menu, 6, 2, 4 (or Menu, 6, 0) and then
press 1 to accept the change.
3
On your machine, press Menu, 6, 2, 2, 1.
22. Setup WLAN
WLAN Enable?
a
On
b
Off
Select ab & OK
Press or to choose
On
(or Off),
then press OK. The wired network interface will
become inactive with this setting.
4
The machine will search for available SSIDs. If
a list of SSIDs is displayed, use the or
keys to choose the SSID you wrote down
in step 1, then press OK. Go to step 8.
22. Setup WLAN
SSID
a
salesgroup
b
ABCgroup
Select ab & OK
Note
It will take a few tens of seconds to display a list of
available SSIDs.
If your access point is set to not broadcast the
SSID you will have to manually add the SSID
name. Go to step 5.
5
Select using or and
press OK. Go to step 6.
22. Setup WLAN
SSID
a
b
ABCgroup
Select ab & OK
6
Enter the SSID you wrote down in step 1. For
information how to type text, see “Entering
Text” in Chapter D of the User’s Guide.
22. Setup WLAN
SSID:
Enter & OK key
7
Press or to choose
Infrastructure
, then press OK.
8
Use the , and OK keys to choose
one of the options below: If your network is
configured for Authentication and Encryption
you must match the settings used for your
network.
No Authentication or Encryption: Choose
Open system
, press OK then choose None
for Encryption Type and press OK. Then
press
or to choose
1.Yes
and
press OK to apply your settings. Go to step 12.
No Authentication with WEP Encryption:
Choose Open system, press OK then use the
or to choose WEP for the
Encryption Type
and press OK. Go to
step 9.
Authentication with WEP Encryption:
Choose Shared Key, press OK. Go to step 9.
Authentication with WPA-PSK (TKIP or AES
Encryption): Choose WPA/WPA2-PSK,
press OK. Go to step 10.
Authentication with LEAP: Choose LEAP,
press OK. Go to step 11.