Brother Computerized Embroidery Machine - Manual (Page 10)

9
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Needle and embroidery foot section
a Thread guide disk
Pass the thread through the thread guide disk when
using the needle threader to thread the needle.
b Needle bar thread guide
Pass the upper thread through the needle bar thread
guide.
c Needle plate
When the needle is lowered, it enters the hole in the
needle plate.
d Needle plate cover
Remove the needle plate cover to clean the bobbin case
and race.
e Bobbin cover/bobbin case
Remove the bobbin cover, and then insert the bobbin
into the bobbin case.
f Embroidery foot “Q”
This presser foot is used for embroidering.
Right-side/rear view
a Handle
Carry the machine by its handle when transporting the
machine.
b Handwheel
Turn the handwheel toward you (counterclockwise) to
raise and lower the needle.
c Embroidery card slot
Insert the embroidery card.
d Air vent
The air vent allows the air surrounding the motor to be
exchanged. Do not cover the air vent while the
machine is being used.
e Power supply jack
Insert the plug on the power supply cord into the power
supply jack.
f Main power switch
Use the main power switch to turn the machine on and
off.
Memo
z Refer to pages 8 through 11 while you are
learning to use your machine.
F-combo-BrotherE_sgml.book Page 9 Thursday, November 17, 2005 3:39 PM