Bakers Pride COUNTERTOP VH1828G - Manual (Page 14)

14. OPERATOR MAINTENANCE
WARNING DANGER DISCONNECT THE POWER SUPPLY BEFORE SERVICING OR CLEANING
THE OVEN. SERIOUS INJURY, INCLUDING DEATH, MAY OCCUR IF CONTACT IS MADE WITH
INCOMING POWER.
CAUTION IF
FUSE BAD, REPLACE ONLY WITH IDENTICAL FUSE. DO NOT SUBSTITUTE HIGHER
VALUE FUSES, AS THIS MAY NULLIFY NEEDED PROTECTION FOR THE
INTERNALELECTRICALCOMPONENTS.
DUAL AIR MODEL VH-SERIES WARNING
ALL SERVICING SHOULD BE PERFORMED ONLY BY A FACTORY AUTHORIZED SERVICE
TECHNICIAN ORAGENT
:
.
.
PUSH IN THE “RESET” BUTTON
The Overload Relay is both a current limiting and a thermal
device
RESET button pushed IN & overload
not overheated
6.
During normal operation of the oven, lubrication is not required.
To achieve maximum efficiency, keep the oven clean. How you maintain your oven will determine how long
it lasts.
If the oven fails to operate, perform the following inspections BEFORE calling an authorized service agent:
1. Check to see if the main circuit breaker is ON at the breaker panel.
2. Check the 10-amp fuse located in the bottom of the Power Control Box
3. Check that the Main Switch is ON. If operating properly, the rocker switch will be lighted
when ON.
4. Check the setting of the temperature control thermostats (knobs). If operating properly, they
will activate the green indicator lights as you turn the knobs back and forth, calling for heat. It
is very unlikely that the light will burn out.
5. If there is no air blowing, check the following:
A : Observing the at the beginning of this
section, open the Power Control Box and locate the overload relay (above
gearmotor). . Try the Main Switch again.
1. NOTE:
, meaning that if one or both of the blower motors get jammed, the
overload relay shuts the motor(s) OFF if there is excessive current going to
the motor(s), or if excessive heat builds up in the overload relay due to an
overload condition. Because it takes time for the relay to cool down, do not
assume that there is another problem IF pushing the RESET button doesn't
accomplish the task. Both settings,
, must be correct for proper operation.
If the conveyor belt does not move, check to see that the coupling setscrew is tight on the
gearmotor output shaft.
If the oven still does not operate, turn OFF the Main Switch and disconnect the power supply to the
unit (if possible). Contact the factory, factory representative, or an authorized service agency.
.
:
14
The Inner and Outer panels are made of stainless steel, and therefore may be exposed to strong
cleaners to remove baked-on grease, etc. Overnight soaking in a hot cleaning solution will improve
the cleaning process.
The Main panel is made of aluminized steel like the main cook chamber, and thus requires the same
level of care to retain its integrity. Follow the same precautions as mentioned above for the main
cook chamber.