Belkin F6C700-EUR - Manual (Page 9)

User replaceable battery
The
Regulator PRO ™ NetUPS Series has a "user-replaceable battery
function" so that users can easily swap the batteries inside the UPS by
themselves. Battery replacement procedures are described in section 6.
Charging current with low ripple and harmonics
A special controlled circuit is used to provide charging current with PFC
(Power Factor Correction). This reduces the conducted electro-magnetic
interference to other facilities sharing the same distribution panel with your
UPS and therefore extends the battery life of the UPS.
Intelligent communication interface and powerful network
support capability
The built-in communication interface (RS-232 and dry contact) allows you to
control and manage your UPS via powerful Belkin Sentry Bulldog Shutdown
Management Software. Moreover, an optional built-in SNMP accessory slot
lets your
Regulator PRO ™ NetUPS be easily managed through a network.
User-friendly interface
You can instantly assess the status of your UPS without pushing any button.
The LED display provides complete and easy to understand information,
such as load level, battery level, intelligent boost, intelligent buck-down,
on battery, replace battery, and overload.
Optional network surge protection
The
Regulator PRO ™ NetUPS Series provides built-in Novell network cable
(RJ-45) jacks. These jacks protect your hardware from surges and spikes that
travel along communication lines. They protect from all potential damage as
a result from surges, spikes, and line-noise.
2-4 Annotation
The two signs shown below indicate that important instructions need to
be followed:
Introduction (continued)
5
En
P73335u_UPS_man.qxd 4/30/01 12:19 PM Page 5