Belkin F6C700-EUR - Manual (Page 15)

En 4. Operation
4-1 Cold Start when utility is not present
Even with the absence of utility power, the UPS can be turned "On".
Just push the ON/TEST button and wait for about two seconds for the
UPS to be turned "On". The INVERTER LED will light followed by a
beep and the UPS is "On".
4-2 Turning 'ON' the UPS
Under normal utility power, push the ON/TEST button for the UPS to be
turned "On". Once the UPS is "On", it will emit a beep and then supply
power to the loads.
4-3 Turning 'OFF' the UPS
Pressing the "Off" button will immediately stop the UPS from supplying
power to loads.
Note: It is possible that the utility power is still present even though
the OFF button has been pressed. To fully turn OFF the UPS, it is
advisable to unplug the power cord.
4-4 UPS Self-Test
Pressing the ON/TEST button when the UPS is in "ON UTILITY MODE"
will make the UPS shift to "ON BATTERY MODE" and automatically
perform a self-test for about 10 seconds. After the self-test, the UPS will
return to "ON UTILITY MODE".
4-5 Silence Function
The buzzer can be turned "On" or "Off" by toggling the ON/TEST
button when the UPS is in "ON BATTERY MODE".
En
11
P73335u_UPS_man.qxd 4/30/01 12:19 PM Page 11