Olympus DS7000 - Manual (Page 24)

2
24
EN
H
a
nds
-fre
e re
cording
/ R
e
cording
m
o
nit
o
r
The recorder can be used as a hands-free recording
device. To set up the recorder for hands-free
operation, connect the optional Olympus Foot
Switch to the back of the docking station and place
the recorder in the docking station as shown in the
illustration below.
You can set the Hands-free function of the recorder
to [ Dictation ] (default) or [ Transcription ] by using
the customize functions of the ODMS software
(
☞ P.44). Using the ODMS software you can also
change the functions of the foot pedals.
For more details, refer to the online help for ODMS
software (
☞ P.47).
It is possible to monitor your recording by listening
to it even while the recording is in progress. In order
to do so, insert the earphone plug into the earphone
jack and use the + or – buttons to control the volume
level.
Notes
• When connecting an earphone or an external
microphone’s plug, insert the plug all the way in
as shown in the illustration above.
• To avoid irritation to the ear, insert the earphone
after turning down the volume level.
• Do not place earphones near a microphone as this
may cause feedback.
+ , − (Volume) button
Hands-free recording Recording monitor
Notes
• Move the slide switch to the STOP ( 4 ) position
before connecting it to the docking station for
hands-free recording.
• To record with better quality using the hands-free
recording function, set the microphone sensitivity
to [ Conference ] mode (
☞ P.37), or use an external
microphone.