Olympus DS-3000 - Manual (Page 49)

49
Check that the volume of [Master] and [Wave] are not set to the minimum settings and that the
[Mute] check box is not selected. (
Play WAVE File)
Play WAVE File
From the Windows [Start] menu, select
Programs, Accessories,
(Windows 95/NT 4.0) Multimedia
(Windows 98/2000) Entertainment
Sound Recorder, File, Open
Open ":\Windows\Media\" and execute playback of any WAVE File (*.wave file).
If the WAVE file does not play or it is playing but the sound cannot be heard, consult your
sound card or PC vendor.
Cannot Connect to DS-3000
1. After connecting the DS-3000 to your PC using an USB cable, check that the LCD display of the
Digital Voice Recorder shows "REMOTE".
2. If "REMOTE" is not displayed, remove the connection cable from the DS-3000 and check that
the stop mode or the hold switch is not enabled.
3. Then, reconnect the communication cable to the DS-3000 and check that the LCD display
shows "REMOTE".
4. If the LCD display still does not show "REMOTE," the communication driver may not be working
properly. In this case, check “Communication Driver Problem” below.
Communication Driver Problem
[Windows 95]
Even if you install the USB transfer kit on Windows 95, you cannot use the
DS-3000/2000/330/320/150/10 with the USB connection.
[Windows 98, and Windows ME]
From the Windows [Start] menu, select
Settings, Control Panel, System
Next, find the DSSUSB1 Device (DSSUSB1 Device for DS-3000, DSSUSB Device for
DS-320/150, DSXUSB Device for DS-330/10) at the root of the [Device Manager] page and
check that it is operating properly. If the DS-3000 is not working properly, enable it.
[Windows 2000, and Windows XP]
From the Windows [Start] menu, select
Settings, Control Panel, System