Olympus PT-018 - Manual (Page 18)

E-17
Insertion of silica gel
Pay attention to the orientation.
Before sealing the Case, insert the accessory silica gel bag (for prevention
of fogging) between the bottom of the camera and the Case. Insert the bag
with the glued longer side to the inside.
:: • Insert the silica gel all the way at the specified location and
with the specified orientation. When the orientation is not
correct, the silica gel bag will be caught when the Case is
sealed and water leakage will be caused.
• Attempting to seal the Case with the bag inserted only part of
the way will cause the silica gel bag to get caught by the O-ring
and water leakage will occur.
• Once silica gel has been used, the moisture absorption
performance will be impaired. Always exchange the silica
gel when the Case is opened and closed.
CAUTION
Set the mode dial.
After the digital camera has been loaded,
push down the mode dial of the Case
from the upper surface of the Case. Set
it so that the lower part of the mode dial
on the inside of the Case fits properly
onto the upper part of the mode dial of
the digital camera itself.
Advice • After setting the mode dial of the Case, set the power of the digital
camera to 'OFF', and before sealing the Case, operate the mode dial
and confirm that the mode of the digital camera is switched.