Olympus SP-700 - Manual (Page 13)

13
En
1 Select the flash mode by repeatedly pressing Y #.
If not used for approximately 2 seconds, the camera applies the current settings, and the
setting screen disappears.
2 Press the shutter button halfway.
When the flash is set to fire, the # mark lights.
3 Press the shutter button completely to take the picture.
Flash working range:
W (max.): Approx. 0.3 to 2.6 m (1.0 to 8.5 ft.)
T (max.): Approx. 0.5 to 2.1 m (1.6 to 6.9 ft.)
To save battery power, the camera automatically enters the sleep mode and stops
operating after a certain period of non-operation. Operate the shutter button or
zoom lever to reactivate the camera. You can adjust the amount of time before
the camera enters sleep mode.
If the camera is not operated for 10 minutes after the camera enters sleep mode,
it automatically closes the lens cover and turns off. To resume operation, turn on
the power again.
Icon Flash Mode Description
No
indication
Auto flash The flash fires automatically in low light or backlight
conditions.
!
Red-eye
reduction flash
The red-eye reduction flash mode significantly reduces this
phenomenon by emitting pre-flashes before firing the
regular flash.
# Fill-in flash The flash fires regardless of the available light.
H
Red-eye fill-in This is a combination of the red-eye reduction flash and fill-
in flash functions. The flash is always fired regardless of
available light and pre-flashes are fired to reduce red-eye.
$ Flash off The flash does not fire even in low light conditions.
Flash Modes
Power Save Feature
d4266_e_basic_00_bookfile_7.book Page 13 Thursday, September 29, 2005 1:17 PM