Olympus VR-320 - Manual (Page 43)

43 EN
For information on using the menus, see “Using the Menu” (p. 4).
For best results, wait at least one minute after taking
or viewing pictures before performing pixel mapping.
If the camera is turned off during pixel mapping, be
sure to perform it again.
To adjust the CCD and the image To adjust the CCD and the image
processing function
processing function
Press the Q button when [Start] (Submenu 2) is
displayed.
The camera checks and adjusts the CCD and the
image processing function at the same time. ●
Adjusting the brightness of the monitor Adjusting the brightness of the monitor
[[s
s]]
s (Settings 2) X s
Submenu 2 Application
Bright/Normal
Selects the monitor brightness
depending on the surrounding
brightness.
Viewing images on a TV [TV Out] (VR-330/D-730) Viewing images on a TV [TV Out] (VR-330/D-730)
s (Settings 2) X TV Out
Different countries and regions use different video signal standards. Before connecting the camera, choose a video
signal standard that matches that used by the TV.
Submenu 2 Submenu 3 Application
Video Out
NTSC
Choose when connecting the camera to TVs in countries or regions
where NTSC is used (e.g., North America, Taiwan, Korea, and Japan).
PAL
Choose when connecting the camera to TVs in countries or regions
where PAL is used (e.g., Europe and China).
HDMI Out 480p/576p / 720p / 1080i Choose an HDMI output format.
HDMI Control
Off Playback operations are performed using camera controls.
On Playback operations are performed using the TV remote control.
Camera factory defaults vary with the country or region of sale.
Viewing images on a TV Viewing images on a TV
Using an AV cable
1
Match the camera video signal format ([NTSC]/[PAL]) to that used by the TV.
2 Connect the camera to the TV.