Olympus VG-130 - Manual (Page 71)

71 EN
Any defect that occurs due to mishandling (such as an
operation performed that is not mentioned in the Handling
Care or other sections of the instructions, etc.)
Any defect that occurs due to repair, modifi cation, cleaning,
etc. performed by anyone other than Olympus or an
Olympus authorized service station.
Any defect or damage that occurs due to transport, a falI,
shock, etc. after purchase of the product.
Any defect or damage that occurs due to fi re, earthquake,
fl ood damage, thunderbolt, other natural disasters,
environmental pollution and irregular voltage sources.
Any defect that occurs due to careless or improper
storage (such as keeping the product under conditions
of high temperature and humidity, near insect repellents
such as naphthalene or harmful drugs, etc.), improper
maintenance, etc.
Any defect that occurs due to exhausted batteries, etc.
Any defect that occurs due to sand, mud, etc. entering the
inside of the product casing.
When this Warranty Certifi cate is not returned with the
product.
When any alterations whatsoever are made to the
Warranty Certifi cate regarding the year, month and date of
purchase, the customer’s name, the dealer’s name, and
the serial number.
When proof of purchase is not presented with this
Warranty Certifi cate.
4 This Warranty applies to the product only; the Warranty does
not apply to any other accessory equipment, such as the
case, strap, lens cap and batteries.
5 Olympus’ sole liability under this warranty shall be limited to
repairing or replacing the product and any liability for indirect
or consequential loss or damage of any kind incurred or
suffered by the customer due to a defect in the product, and
in particular any loss or damage caused to any fi lm or lenses
or other equipment or accessories used with the product or
for any loss resulting from delay in repair, is excluded.
Notes;
1 This Warranty is in addition to and does not affect the
customer’s statutory right.
2 lf you have any queries regarding this Warranty, call any
of the Olympus authorized service stations listed in the
instructions.
a.
b.
c.
d.
e.
f.
g.
h.
i.
j.
Notes regarding warranty maintenance
1 This Warranty will only be valid if the Warranty Certifi cate is
duly completed by Olympus or the dealer. Make sure that
your name, the name of the dealer, the serial number and the
year, month and date of purchase are all completed.
2 Since this Warranty Certifi cate will not be re-issued, keep it in
a safe place.
3 Any request for repair by a customer in same country where
the product was purchased shall be subject to the terms
of the warranty issued by the Olympus distributor in that
country. Where the local Olympus distributor does not issue a
separate warranty or where the customer is not in the country
where the product was purchased the terms of this worldwide
warranty shall apply.
4 Where applicable, this Warranty is valid worldwide. The
Olympus authorized service stations listed in this Warranty
will gladly honor it.
* Please refer to the appended list for the authorized
international Olympus service network.
Disclaimer of Warranty
Olympus makes no representations or warranties, either
expressed or implied, by or concerning any content if these
written materials or software, and in no event shall be liable
for any implied warranty of merchantability or fi tness for any
particular purpose or for any consequential, incidental or
indirect damages (including but not limited to damages for loss
of business profi ts, business interruption and loss of business
information) arising from the use of inability to use these written
materials or software. Some states do not allow the exclusion or
limitation of liability for consequential or incidental damages, so
the above limitations may not apply to you.
Trademarks Trademarks
IBM is a registered trademark of International Business
Machines Corporation.
Microsoft and Windows are registered trademarks of Microsoft
Corporation.
Macintosh is a trademark of Apple Inc.
SDHC logo is a trademark.
All other company and product names are registered
trademarks and/or trademarks of their respective owners.
The standards for camera fi le systems referred to in this
manual are the “Design rule for Camera File system/DCF”
standards stipulated by the Japan Electronics and Information
Technology Industries Association (JEITA). •
•
•
•
•
•