Olympus STYLUS 7010 - Manual (Page 26)

26 EN
Adjusting to a natural color scheme [WB]
B CAMERA MENU WB
: K s I A
Submenu 2 Application
AUTO
The camera automatically adjusts
the white balance according to the
shooting conditions.
5
For shooting outdoors under a clear
sky
3
For shooting outdoors under a
cloudy sky
1 For shooting under tungsten lighting
w
For shooting under daylight
fl uorescent lighting (household
lighting, etc.)
x
For shooting under neutral
fl uorescent lighting (desk lamps, etc.)
y
For shooting under white fl uorescent
lighting (offi ces, etc.)
Selecting the ISO sensitivity [ISO]
B CAMERA MENU ISO
: K
Abbreviation for the International Organization
for Standardization. ISO standards specify the
sensitivity for digital cameras and fi lm, thus
codes such as “ISO 100” are used to represent
sensitivity.
In the ISO setting, although smaller values
result in less sensitivity, sharp images can be
taken under fully lit conditions. Larger values
result in higher sensitivity, and images can
be taken at fast shutter speeds even under
low light conditions. However, high sensitivity
introduces noise into the resulting picture,
which may give it a grainy appearance.
Submenu 2 Application
AUTO
The camera automatically adjusts the
sensitivity according to the shooting
conditions.
HIGH ISO AUTO
The camera uses a higher sensitivity
compared to [AUTO] to minimize blur
caused by a moving subject or by
camera shake.
64/100/200/400/
800/1600 Set ISO sensitivity to a numerical
value.
Shooting pictures sequentially while the
shutter button is held down [DRIVE]
B CAMERA MENU DRIVE
: K s
Submenu 2 Application
o
One frame is shot each time the
shutter button is pressed.
j *1
Take sequential shots using the
focus, brightness (exposure) and
white balance set in the fi rst frame.
c
The camera takes sequential shots at
a faster speed than in [j].
d
The camera takes sequential shots at
approximately 11 frames/sec.
*1 The shooting speed varies depending on the settings
for [A IMAGE QUALITY] (p. 25).
When set to [j], the fl ash (p.19) cannot
be set to [REDEYE]. In addition, when set to
[
c], the fl ash is limited to either # (FILL IN)
or $ (FLASH OFF). When set to [d], the
fl ash is fi xed to $ (FLASH OFF).
When set to [ c] or [d], [IMAGE SIZE] is
limited to [ I] or lower, and [ISO] is fi xed to
[AUTO]. Moreover, [FINE ZOOM] (p. 27) and
[DIGITAL ZOOM] (p. 27) are not available.
When set to [j], [ c], or [d], [R] (sound
recording) (p. 28) is not available.