AEG F99709M0P - Manual (Page 31)

You can turn the selector of
the released quantity (B)
between position 1 (lowest
quantity) and position 4 or 6
(highest quantity).
9. DAILY USE
1. Open the water tap.
2. Press the on/off button to activate
the appliance.
Make sure that the appliance is in
programme selection mode.
• If the salt indicator is on, fill the salt
container.
• If the rinse aid indicator is on, fill the
rinse aid dispenser.
3. Load the baskets.
4. Add the detergent. If you use multi-
tablets, activate the option Multitab.
5. Set and start the correct programme
for the type of load and the degree
of soil.
9.1 Using the detergent
30
20
A B D
C
20 30
B A D
C
1. Press the release button (B) to open
the lid (C).
2. Put the detergent, in powder or
tablets, in the compartment (A).
3. If the programme has a prewash
phase, put a small quantity of
detergent in the compartment (D).
4. If the programme has a prewash
phase, put a small quantity of
detergent on the inner part of the
appliance door.
5. Close the lid. Make sure that the
release button locks into position.
9.2 Setting and starting a
programme
The Auto Off function
This function allows to decrease energy
consumption by deactivating
automatically the appliance when it is not
operating.
The function deactivates the appliance:
• After 5 minutes from the completion
of the programme.
• After 5 minutes if the programme has
not been started.
Starting a programme
1. Press the on/off button to activate
the appliance. Make sure that the
appliance is in programme selection
mode.
2. Close the appliance door.
3. Press Program again and again until
the indicator of the programme you
want to select comes on.
The display shows the programme
duration.
4. Set the applicable options.
5. Press Start to start the programme.
• The washing phase indicator comes
on .
• The programme duration starts to
decrease with steps of 1 minute.
ENGLISH 31