English, Operation – AEG AR 4021 BT User Manual

Page 86

ENGLISH

Operation

This chapter gives important operating instructions for

the unit.

NOTE

Several buttons can be found on the unit as well as

►

on the remote control. Identical buttons perform the

same function. The buttons appear in the following

text are the buttons on the unit.

The remote control signals are sent to the unit via

►

infrared light. The transmission of the signals from

the remote control to the unit may be impaired by

direct sunlight on the IR sensor (6).

On/Off

Press the button

/MUT

(2) to switch on the set. The

display is activated.

Hold down the

/MUT

(2) button to switch the unit

off.

Settings

Volume

WARNING

Hearing damage due to high volume!

High volumes can permanently damage your hearing.

Set a moderate volume.

►

Press the

/ buttons (23) to adjust the volume.

Switch unit to mute

Press the

/MUT

(2) button to switch the unit to

mute.

MUTE

flashes on the display.

Press the

/MUT

(2) button again to deactivate the

function.

Sound Settings

Press the

SEL

button (5). The current volume is dis-

played. Press the

SEL

button again to open the next

setting.

The following settings are possible:

VOL - volume (0 to 100)

BAS - bass (-10 to +10)

TRB - treble (-10 to +10)

BAL - Balance (sound distribution between left and

right speakers) (10L to 10R)

FAD - Fader (sound distribution between rear and front

speakers) (10F to 10R)

Press the

/ buttons (23), to change the displayed

setting.

More settings via the SEL button

Keep the

SEL

button (5) pressed for a few seconds to

open more settings options. Press the

SEL

button again

to open the next setting.

Press the

/ buttons (23), to change the displayed

setting.

The following settings are possible:

BEEP

Key tone:

BEEP ON:

■

The unit sounds a beep tone

every time you press a button.

BEEP OFF:

■

The unit sounds no beep tone.

P-VOL

Adjusts the volume at which the unit should

switch on.

AREA

Region, when the unit is used.

Europe (

EUR

) or

USA

NOTE

Changing this setting deletes all station

►

presets.

HOUR

Select the time display here.

24 hour (24 H) or 12 hour (12 H)

NOTE

If 12 hours is selected, the display shows:

►

AM = morning, PM = afternoon.

PCLK

Select here if the time should be displayed

when the unit is switched off.

Radio Reception Settings

Keep the

PTY

button (17) pressed for several seconds

to open more setting options. Press the

PTY

button

again to open the next setting.

Press the

/ buttons (23) to change the displayed

setting.

The following settings are possible:

Traffic announcements

TA SEEK:

■

With activated TA function the

unit searches for a station with traffic an-

nouncements.

TA ALARM:

■

No automatic station search.

The unit sounds a beep tone if no traffic

information is received and

NO TP/TA

is dis

played.

SEEK PI

is displayed if the selected

station does not transmit an RDS signal.

Moving into an area where two stations

with identical AF, but different Pl code (PI =

program information) are received destabilizes

reception. In this situation you have two op-

tions:

PI SOUND:

■

To change stations the other

station is played for less than one second.

PI MUTE:

■

The other station is muted.

RETUNE

Delay for automatic search with traffic an-

nouncements and/or program information:

■

(Short) after approx. 30 seconds

■

(Long) after approx. 90 seconds