Binatone SPEAKEASY COMBO 2005 TRIPLE - Manual (Page 33)

31
REGISTRATION
IMPORTANT: When you purchase your phone system, all handsets are
already registered to your base, so you do not need to register them.
To check whether a handset is registered, make sure mains power to the
base unit is switched on and the handset is within range. The handset's
display should show its number and the should be steadily
on. If the display shows "REGISTER", you need to register the
handset again using the following process:
Handset registration is only necessary when you buy extra handsets or if a
You can register additional handsets to have up to five handsets per base
unit, with each handset's number (1 to 5) shown on its display.
(Note: each handset can only be registered to one base.)
handset has become faulty.
9
On the cordless handset:
1. Press
PIN ?” , enter the 4-digit PIN code for
“PLEASE WAIT” .
On the base:
2. Press
3. Press
4. At the same time, press and hold the key for about 5 seconds
the base (default PIN code is 0000).
the handset returns to idle mode with its handset number displayed and
5. A confirmation beep is played to indicate successful registration, and
or until it beeps, to indicate the base is in registration mode.
the antenna icon steady.
If registration fails, the handset beeps and the display returns to show
REGISTER and the antenna icon continues to flash.