En g l is h english, Programmed play, Cleaning and maintenance – AEG SRR 4317 User Manual

Page 42: Troubleshooting

ENGLISH

Press three times = the selected folder of the MP3 CD is repea-

ted continuously (REP. ALBUM appears in
the display).

Press four times = the display contains the word RND, MP3

and the track number that is to be played
ﬁ rst. All tracks are played back in random
order.

Press ﬁ ve times = the function is deactivated and the CD is

played in the normal mode.

Programmed Play

This can be used to program any desired sequence of tracks.

1. Press

the

˾ STOP key (15).

2. Press the PROGRAM key (17). The number „P01“ (storage

location) and the symbol PROG ﬂ ash in the display. Use the
I

̇̇ SKIP DOWN / ̈̈I SKIP UP buttons (20/19) to select

the desired track and then press the PROGRAM button
again. The display changes to memory slot P02.

3. Select the next track with the I

̇̇ SKIP DOWN / ̈̈I

SKIP UP key and press the PROGRAM key again. Repeat
the procedure until all the desired tracks are selected.

NOTE:

Once the storage capacity of the tracks to be programmed
has been reached, „FUL“ ﬂ ashes in the display.

4. Press

the

̈II PLAY/PAUSE key (24). The playback starts.

The selected track numbers are shown in the display in the
correct order and the symbol

̈ or ̈ MP3 and PROG. light

up. Press this button to pause brieﬂ y the playback.

5. Press once the

˾ STOP key (15) to stop the playback while

retaining the program.

6. To resume the playback of the program press ﬁ rst the

PROGRAM key once and then the

̈II PLAY/PAUSE.

7. In order to delete the programme, hold the PROGRAM key

down for approximately 3 seconds in stop mode. The words
„no PROG“ ﬂ ash brieﬂ y in the display. The PROG. control
lamp goes out.

The device stops automatically once the entire sequence of pro-
grammed tracks is completed. The programmed order of tracks
remains in the memory until you change to a different mode,
remove the CD from the CD compartment or switch off the device.

It is also possible to combine the programmed tracks with the
REPEAT function. After you have programmed and started the
device, please press the MODE button (16) up to four times and
then you can use the functions as described under „MODE“.

Playing back Music in MP3 Format

With this device it is possible to play back pieces of music in
MP3 format. The device also supports all standard CD types:
CD, CD-RW, CD-R.

This machine of is able to play MP3 CDs. Up to 200 tracks
can be compressed and stored on these CDs. Your machine
detects an MP3 CD automatically (the total number of tracks
and MP3s appears in the display). If you would like to play one
of these CDs, proceed as described under „Playing CDs/MP3“.
Tracks can be programmed as described under „Playing Back

Programmed Tracks“.

Please note:
There are a number of different recording and compression
methods, as well as quality differences between CDs and self-
recorded CDs.

Furthermore, the music industry does not adhere to ﬁ xed
standards (copy protection).

For these reasons it is possible that in rare cases there are
problems with the playback of CDs and MP3 CDs. This is not a
malfunction of the device.

Cleaning and Maintenance

• Always remove the mains plug before cleaning the machine.
• Any marks on the surface can be wiped off with a slightly

damp cloth without any additives.

NOTE: Compact Disks

• This device is able to play CDs with a diameter of

8 cm and 12 cm.

NOTE:

Only place one disc in the CD compartment at a
time.

• Only audio CDs, CD-R and CD-RW disks can be

played on this machine.

• Always place the CD into the CD compartment with

the label facing upwards. Compact discs can only be
played on one side.

• Fingerprints and dust should be carefully removed

from the recorded side of the CD (the side without the
label) with a soft cloth. Wipe off in straight lines from
the centre to the edge.

• After being played, CDs should be returned to their

case so that they do not become scratched.

• Do not expose CDs to direct sunlight, high humidity

levels or prolonged high temperatures in order to
prevent them from warping.

• Do not adhere any paper to the CD or write on it.
• Do not spray any cleaning agents or antistatic sprays

on to the CD as in the case of phonographs.

Troubleshooting

Symptoms

Course

Solution

CD can not be
played back.

CD is not inserted
or inserted incor-
rectly.

Ensure that the
disc is inserted with
the label facing
upwards.

Batteries too weak. Insert new batteries

or operate the
device with the
mains lead.

CD jumps during
playback.

Check the disc for
ﬁ ngerprints, dirt or
scratches.

05-SRR 4317 AEG.indd 42

19.11.2007 9:16:08 Uhr