AEG SCS51800F0 - Manual (Page 14)

Problem Possible cause Solution
dEMo appears on
the Display. The appliance is in dem-
onstration mode (dEMo). Keep pressed approxi-
mately 10 sec. the OK but-
ton since a long sound of
buzzer is heard and the
Display shut off for a short
while: appliance start
works regularly.
6.1 Replacing the lamp
CAUTION!
Disconnect the plug from the
mains socket.
1. Press on the rear hook and at the same
time slide the cover in the direction of
the arrow.
2. Replace the lamp with one of the same
power and specifically designed for
household appliances. (the maximum
power is shown on the light bulb cov-
er).
3. Fix the lamp cover into its original posi-
tion.
4. Connect the plug to the mains socket.
5. Open the door. Make sure that the
light comes on.
6.2 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to "Installation".
3. If necessary, replace the defective
door gaskets. Contact the Service
Center.
7. INSTALLATION
WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
7.1 Positioning
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
Cli-
mate
class Ambient temperature
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
14 www.aeg.com