AEG L61271WDBI - Manual (Page 35)

• Connect the water inlet hose to the
cold water tap with 3/4 thread.
CAUTION!
Make sure that there are no leaks
from the couplings.
Do not use an extension hose if
the inlet hose is too short. Con-
tact the service centre for the re-
placement of the inlet hose.
Water pressure
The appliance works correctly if the wa-
ter pressure is not less than 0.05 MPa
(0.5 bar).
If you can not connect the water inlet
hose to the cold water tap of the primary
hydraulic system, connect it to your do-
mestic cold water storage system.
Make sure not to have more than a dis-
tance of 5.02 m (16.5 ft) between the ap-
pliance inlet hose and the bottom of the
water storage tank.
Water-stop device
A
The inlet hose has a water stop device.
This device prevents water leaks in the
hose because of its natural ageing. The
red sector in the window «A» shows this
fault .
If this occur, close the water tap and
contact the service centre to replace the
hose.
13.5 Water drainage
There are different procedures to con-
nect the drain hose:
With the plastic hose guide.
ENGLISH
35