AEG L61271WDBI - Manual (Page 11)

5.10 EXTRA RINSE BUTTON
9
Touch button 9 to add rinsing phases
to a programme.
Use this function for persons allergic to
detergents and in areas where the water
is soft.
5.11 STAINS, PREWASH AND
SOAK BUTTON
10
Touch button 10 to set one of the these
functions:
5.12 STAINS
Use this function for laundry with hard
stains to remove.
When you set this function, put the stain
remover into compartment
.
The programme duration increa-
ses.
This function is not available with
a temperature lower than 40° C.
5.13 PREWASH
Use this function for heavy soil.
The appliance adds a prewash phase to
the main wash.
The programme duration increases.
5.14 SOAK
Use this function for heavy soil.
The appliance soaks the laundry at 30°C
for about half an hour before to wash.
5.15 SPIN BUTTON 11
Touch button 11 to:
• Decrease the maximum speed of the
spin phase of the programme.
The display shows only the spin
speeds available with the set
programme.
• Deactivate the spin phase (' No Spin '
function).
• Activate the ' Rinse Hold ' function.
Set this function to prevent fabric
creases. The appliance does not drain
the water when the programme is
completed.
5.16 TEMPERATURE BUTTON
12
Touch button 12 to change the default
temperature.
Symbols - - - and
= cold water
5.17 Acoustic signals function
You can hear the acoustic signals when:
• You activate the appliance.
• You deactivate the appliance.
• You touch the buttons.
• The programme is completed.
• The appliance has a malfunction.
To deactivate/activate the acoustic sig-
nals, touch button
10 and button 9 at
the same time for 6 seconds.
If you deactivate the acoustic sig-
nals, they continue operate only
when you touch the buttons and
when a malfunction occurs.
5.18 Child lock function
This function prevents children to play
with the control panel.
• To activate the function, touch button
12 and button 11 at the same time
until the display shows the symbol .
• To deactivate the function, touch but-
ton 12 and button 11 at the same
time until the symbol goes off.
You can activate the function:
• Before you touch the button
6 : the
appliance cannot start.
• After you touch the button
6 , all the
buttons and the programme knob are
deactivated.
5.19 Permanent extra rinse
function
With this function you can keep the extra
rinse function permanently on when you
set a new programme.
• To activate the function touch button
8 and button 7 at the same time
until the display shows the symbol .
ENGLISH
11