AEG Solo 15 - Manual (Page 17)

16
UK
14.2 Register Additional Handsets
• Press and hold the key under the base unit for approximately 5 seconds.
>The message indicator on the base will flash for up to 1 minute, while it is in registration mode.
• On the handset, press
• Press to “ADVAnCED SET” and then press to select.
• Press to “REGISTRATIOn” and then press to select.
>If no action is taken on the handset within 10 seconds, the registration procedure will be aborted. If
this happens, repeat from step 1.
• Enter the Master PIn and then press to confirm.
Note:
The default Master PIn is 0000.
>WAITInG flashes on the screen.
>A confirmation tone is played to indicate successful registration, and the handset will return to standby
mode, with its handset number displayed.
>If no base is found with the entered PIn, error tones are played to indicate failed registration and the
handset returns to standby mode. You will need to repeat from step 1 above.
14.3 Un-register your Handset
You can unregister the handset you are using.
• From the home screen, press
• Press to “ADVAnCED SET” and then press to select.
• Press to “UnREGISTER” and then press to select.
• Enter the Master PIn and then press to confirm.
Note:
The default Master PIn is 0000.
• Press to select the handset number to un-register and then press to confirm or press to
cancel the un-registration procedure.
>A confirmation tone is played to indicate successful un-registration.
>If no action is taken on the handset within 15 seconds, the un-registration procedure will be aborted
and the handset returns to standby mode.
14.4 Change the Master PIN
The Master PIn is used for registration/un-registration of handsets and for accessing the answering
machine remotely. The default Master PIn number is 0000. The maximum length of the Master PIn is 8
digits.
Note:
If you forget your PIn code, you can reset it to its default 0000 using a handset Reset. (See Reset the Unit.)
• From the home screen, press
• Press to “ADVAnCED SET” and then press to select.
• Press to “CHAnGE PIn” and then press to select.
• Enter the current Master PIn and then press to confirm.
>The PIn will be shown as asterisks (*) on the screen as you enter them.
• Enter the new PIn and then press to confirm.
>A confirmation tone is played.
14.5 Set the Auto Prefix
You can set the phone to detect a dialling number and replace it with another number.
You can enter up to 5 digits for the number to be detected, which can be replaced with an auto prefix
number of up to 10 digits.
• From the home screen, press
• Press to “ADVAnCED SET” and then press to select.
• Press to “AUTO PREFIX” and then press to select.
• Press again to enter “DETECT DIGIT”.