AEG Charger LK 1204 - Manual (Page 22)

22
▪
never short circuit the device or connect the inlets and outlets of the device using
metal objects only use the supplied connecting cables to connect the device to
a battery
▪
If an extension cable is used, the cable diameter must be sufficient for the power
required by the device
▪
Check the input voltage (230 V aC) and ensure that it corresponds to the mains
voltage; otherwise the device may be damaged
▪
always make sure that the device is disconnected from the mains when you
connect it and disconnect it to a battery
▪
always connect the positive clamp (red) to the positive battery pole (not connec-
ted to the chassis of the car, marked with P or +)
▪
Then connect the negative clamp (black) to the car chassis, away from the bat-
tery casing of the car, away from the battery and the fuel line The charger can
then be connected to a suitable power socket
▪
after charging, first disconnect the charger from the power supply Then, in
this sequence, disconnect the cable to the car chassis (-), and then the battery
connection (+)
▪
do not look at the battery when connecting the charger to the power supply
Warning!
▪
never try to charge damaged, non-rechargeable or frozen batteries
▪
This charger is only suitable for the listed batteries (maintenance-free, sealed,
lead-acid batteries (sla) or gel batteries) and may not be used to charge
non-rechargeable, niCd or other types of batteries do not use it for any other
purposes
▪
do not use the charger to charge dry cell batteries These may explode and
cause injury to persons or material damage to property
▪
do not use the device as a power supply for an electrical low voltage system
▪
ensure that you have read and understood the instruction manual and all safety
instructions that were supplied with the battery to be charged or the vehicle