AEG Style 15 - Manual (Page 9)

9
UK
8 TELEPHONE OPERATION
8.1 Ringer volume
The ringer high / low switch located at the back of the base unit, allows you to adjust the volume of
the ringer.
High volume
Low volume
8.2 To make a call
tLift the handset or press the speakerphone button on the base unit.
>Check for dial tone.
tDial the telephone number.
>The display shows the duration of the call in minutes and seconds.
OR Using pre-dialling:
tDial the telephone number.
>If you make a mistake you can correct it by using the delete button to delete digits and then
adding the right ones.
tLift the handset or press the speakerphone button on the base unit to dial out the number.
8.3 To answer a call
tWhen the phone rings, lift the handset or press the speakerphone button on the base unit.
>The display shows the duration of the call in minutes and seconds.
8.4 To adjust the speakerphone volume
tDuring a call, adjust the volume of the speakerphone to your comfortable volume level using the
volume buttons located on the top of the base unit.
>The display shows the volume level from 1 to 6 in the lower left corner of the LCD screen.
8.5 To end a call
>Replace the handset on the base or press the speakerphone button on the base unit.
8.6 To switch between the handset and the speakerphone
tDuring a phone conversation through the handset press the speakerphone button to speak
hands-free.
>The Speakerphone icon on the display will turn on, but conversation remains through the handset
until the handset is replaced on the base unit. While in speakerphone mode, lift the handset to
enable a private conversation.
8.7 To mute the mouthpiece or microphone
During a call, you can mute the microphone or the mouthpiece so that the person on the other end
cannot hear you.
tPress the mute button .
>While the microphone is muted, “MUTE” will flash in the lower right corner of the display, and the
mute icon will also flash.
tPress the mute button again to get back to the call.
8.8 LCD screen backlight
The display backlight will turn on for 15 seconds every time any button is pressed or when ringing is
received.