AEG BE7314401 - Manual (Page 27)

Removing the door
1.
Open the door as far as it goes.
2. Fully press clamping levers (A) on the
two door hinges.
3. Close the door until the first position
(angle approximately 70°).
4. Hold of the door with one hand on each
side and pull it away from the at an up
angle.
To install the door follow the procedure in
reverse.
The number of glass panels if different for the different models.
CAUTION!
Put the door with the outer side down on a soft and level surface to prevent scratches.
Removing and cleaning the door glass panels
1.
Remove the door.
2. Hold the door trim (B) on the top edge
of the door at the two sides and push
inwards to release the clip seal.
3. Pull the door trim to the front to re-
move it.
4. Hold the door glass panels on their top
edge one by one and pull them up out
of the guide
5. Clean the door glass panels.
To install panels follow the procedure in re-
verse. Install the smaller panel first, then the
larger.
WHAT TO DO IF…
WARNING!
Refer to "Safety information" chapter.
A
A
B
What to do if… 27