Asus Pentium 4 1U Rackmount Server AP160R-S - Manual (Page 31)

ASUS AP160R-S 1U Rackmount Server 31
2.9 Installing CD-ROM and floppy drives
1. When shipped, the rails of the
combo drive cage are attached
to the sides as shown. Remove
the screw closer to the front
and set it aside.
2. Loosen the other screw closer
to the rear side. Do not remove
the screw completely.
3. Turn the rail 180 degrees. The
screw hole on the rail should
align to the hole on the side of
the cage.
4. Secure the rail with the screw
that you removed earlier.
Tighten the other screw.
The slim-type CD-ROM drive and slim-type floppy drive are contained in an
external combo drive cage. You will need these drives when installing the
drivers, utilities, and software applications. The drives are not hot-swappable
so you should install them before powering up the system. However, you
can detach the cage from the chassis when you do not need it anymore. No
need to shut down the system.
The combo drive cage and drives are NOT standard shipping items
in the AP160R-S system package. These items are sold separately.
NOTE
Remove this screw
Loosen this screw