AEG L61270WDBI - Manual (Page 16)

If you turn the programme dial to
another programme when the ap-
pliance is working, the yellow pilot
light of button 8 blinks 3 times.
The display shows the message
Err to indicate a wrong selection.
The machine will not perform the
new set programme.
SETTING THE SPIN SPEED
(BUTTON 2)
When you set the programme, the appli-
ance automatically proposes the maxi-
mum spin speed allowed by that pro-
gramme.
Press this button repeatedly to change
the spin speed. The relevant light will
light up.
RINSE HOLD : the water of the last rinse is
not emptied out to prevent the fabrics
from creasing. When the programme has
finished the display shows a blinking .
The DOOR pilot light goes on.
The pilot light of button 8 is off. The door
is blocked to indicate that the water must
be emptied out.
To empty the water out please read
chapter «At the end of the pro-
gramme».
SETTING THE STAIN OPTION
(BUTTON 3)
Set this option to treat heavily soiled or
stained laundry with stain remover
The appliance extends the main wash
phase and intensifies the stain action
phase. The relevant light illuminates.
This option is not available with a
temperature lower than 40°C.
If you wish to perform a programme with
the stain option, pour stain remover into
compartment
.
SETTING THE TIME SAVING
OPTION (BUTTON 4)
This option allows you to modify the
washing time, automatically proposed by
the appliance.
Press button 4
once
DAILY The relative pilot light
comes on.
The washing duration will be
reduced to wash daily soiled
laundry.
Press button 4 twice
SUPER
QUICK The relative pilot light re-
mains lit.
The washing duration will be
reduced to wash lightly
soiled laundry or items used
or worn for a short time.
The display shows the decreased washing
time.
SETTING THE EXTRA RINSE
OPTION (BUTTON 5)
This appliance is designed for saving wa-
ter.
However, for people with a very delicate
skin (allergic to detergents) it may be nec-
essary to rinse the laundry using an extra
quantity of water (extra rinse).
The appliance will perform some addi-
tional rinses.
STARTING THE PROGRAMME
(BUTTON 8)
Press the button 8 to start the pro-
gramme. The corresponding red pilot
light stops blinking.
The pilot light A is on to indicate that the
appliance starts operating.
The pilot light C is on to indicate the door
is locked.
Press the button 8 to interrupt a pro-
gramme which is running. The corre-
sponding red pilot light starts blinking.
Press the button 8 again to restart the
programme from the point at which it was
interrupted
If you have chosen a delayed start with
button 9, the machine will begin the
countdown.
If you set an incorrect option, the yellow
pilot light of the button 8 blinks for 3
times. The display shows the message Err
for some seconds.
16 www.aeg.com