Konica Minolta BIZHUB C450 - Manual (Page 67)

2 Administrator Operations
2-48 C450
Ad
minist
ra
to
r Op
er
at
ions
Chapter 2
3
Enter the currently set 8-digit Administrator Password from the key-
board and keypad.
– Press the [C] key to clear all characters.
– Touch [Delete] to delete the last character entered.
– Touch [Shift] to show the upper case/symbol screen.
– Touch [Cancel] to go back to the Security Setting screen.
4
Touch [OK].
? What if an Administrator Password different from that is currently
registered is mistakenly entered?
% If there is a mismatch between the currently registered Administra-
tor Password and the Administrator Password entered, a message
appears that tells that there is a mismatch in the Administrator
Passwords. Enter the correct Administrator Password.
% If the Enhanced Security mode is set to [ON], entry of a wrong pass-
word is counted as unauthorized access. If a wrong Administrator
Password is entered a predetermined number of times (once to
three times) set by the Administrator of the machine, the Utility
screen appears and the machine is set into an access lock state. To
cancel the access lock state, turn off, and then turn on, the main
power switch of the machine. When the main power switch is
turned off, then on again, wait at least 10 seconds to turn it on after
turning it off. If there is no wait period between turning the main
power switch off, then on again, the machine may not function
properly.
Here is the sequence, through which the main power switch and
sub power switch are turned on and off:
Turn off the sub power switch
→ Turn off the main power switch →
Turn on the main power switch → Turn on the sub power switch
c450_security_E.book 48 ページ ２００７年４月１１日 水曜日 午前１０時３２分