beautypg.com

2 internal connectors, 24 chapter 2: hardware information, P5ld2 floppy disk drive connector – Asus Motherboard P5LD2 User Manual

Page 46: Floppy, P5ld2 raid connectors, Pri_eide sec_eide

background image

2-24

Chapter 2: Hardware information

2.7.2 Internal connectors

1. Floppy disk drive connector (34-1 pin FLOPPY)

This connector is for the provided floppy disk drive (FDD) signal cable.

Insert one end of the cable to this connector, then connect the other

end to the signal connector at the back of the floppy disk drive.

Pin 5 on the connector is removed to prevent incorrect cable connection

when using a FDD cable with a covered Pin 5.

P

5

L

D

2

®

NOTE: Orient the red markings on

the floppy ribbon cable to PIN 1.

P5LD2 Floppy disk drive connector

PIN 1

FLOPPY

2. ITE IDE connectors (40-1 pin PRI_EIDE [red], SEC_EIDE [red])

These connectors are for Ultra ATA 133/100/66 signal cables. The

ITE IDE connectors support up to four IDE hard disk drives for easier

data storage and data transfer.

P

5

L

D

2

®

P5LD2 RAID connectors

NOTE: Orient the red markings

(usually zigzag) on the IDE

ribbon cable to PIN 1.

PRI_EIDE

SEC_EIDE

PIN 1

PIN 1

• Make sure that you install the ITE 8211 IDE Driver from the support

CD before using the IDE device attached to any of these connectors.

See Chapter 5 for details.

• These connectors do not support ATAPI devices.

This manual is related to the following products: