14 smb setting function, Setting the netbios name – Konica Minolta bizhub 754 User Manual
Page 50
bizhub 754/654
2-38
2.14
SMB Setting Function
2
2.14
SMB Setting Function
When access to the machine by the administrator of the machine through the Administrator Settings is au-
thenticated, the machine enables setting of the NetBIOS Name.
Setting the NetBIOS Name
0
For the procedure to call the Network Settings screen on the display, see steps 1 and 2 of page 2-29.
0
Do not leave the machine with the setting screen of Administrator Settings left shown on the display. If
it is absolutely necessary to leave the machine, be sure first to log off from the Administrator Settings.
1
Call the Network Settings screen on the display from the control panel.
2
Touch [SMB Settings].
3
Touch [Print Settings].
4
Touch [NetBIOS Name].
5
Enter the NetBIOS Name.
6
Touch [OK].
7
Touch [OK].
8
Touch [Close].
% If a message appears that prompts you to turn OFF and ON the main power switch, turn OFF and
ON the main power switch. When the main power switch is turned off, then on again, wait at least
10 seconds to turn it on after turning it off. If there is no wait period between turning the main power
switch off, then on again, the machine may not function properly.
Here is the sequence, through which the main power switch and sub power key are turned on and
off:
Turn off the sub power key ö Turn off the main power switch ö Turn on the main power switch ö
Turn on the sub power key