ATEN CS-1708 - Manual (Page 35)

4. OSD Operation
27
F5 SKP
Skip (SKP) Mode enables you to easily skip backward or forward - switching
the console focus from the currently active computer port to the previous or
next available one.
Š The selection of computers to be available for Skip Mode switching is
made with the Scan/Skip Mode setting under the F3 SET function (see
page 21).
Š When you are in Skip Mode, press [
←
] to switch to the previous
computer in the List; press [
→ ]
to switch to the next computer in the
List; press [
↑ ]
to switch to the last computer on the previous station in
the List; press [
↓ ]
to switch to the first computer on the next station in the
List.
Note: When you Skip, you only Skip to the previous or next available
computer that is in the Scan/Skip Mode selection (see page 22).
Š If a Port has been selected for Scan/Skip Mode, when the focus switches to
that port a Left/Right Triangle symbol appears before its Port ID Display
to indicate so.
Š While Skip Mode is in effect, the console will not function normally. You
must exit Skip Mode in order to regain control of the console.
Š To exit Skip Mode, press [Spacebar] or [Esc].
cs1708-1716.book Page 27 Thursday, July 19, 2007 3:06 PM