ATEN CS-1708 - Manual (Page 56)

CS-1708 / CS-1716 User Manual
48
Administrator Login Failure
If you are unable to perform an Administrator login (because the Username and
Password information has become corrupted, or you have forgotten it, for
example), you can clear the login information with the following procedure:
1. Power off the switch and remove its housing.
2. Short the jumper labeled Default Password at the right front of the switch's
main board.
3. Power on the switch.
When you power the switch on, the following message appears on the
LCD display:
USERNAME AND PASSWORD INFORMATION HAS BEEN CLEARED.
PLEASE POWER OFF THE SWITCH, REMOVE THE JUMPER, CLOSE
THE CASE, THEN RESTART.
4. After you start back up, the OSD login function acts exactly the way it did
the first time the switch was run (see page 17), and you can reset
passwords for the Administrators and Users.
cs1708-1716.book Page 48 Thursday, July 19, 2007 3:06 PM