Internet access, Router mode/ ip over atm (rfc1577) – Abocom AR1000 User Manual
Page 6
- 5 -
INTERNET ACCESS
Router Mode/ IP over ATM (RFC1577)
(1) Run the “router.exe” file saved in the configuration utility. (Go to Start ÆProgramÆ
ADSL Router xx Configuration UtilityÆConfiguration Utility.)
(2) Select a PC COM port available on your computer used to connect to the ADSL Router’s
“Console” port.
(3) Check “Router Protocol” and select “IP over ATM”.
(4) Click “Properties” button.
(5) Enter “ADSL IP”, “Gateway IP”, and “Subnet Mask” addresses provided by your
service provider.
(6) Usually Ethernet IP addresses were not provided by service providers. Check to make
sure if this is your case, if yes, remember to select “Enable NAT function.”
(7) Enter the VPI and VCI numbers. Typically VPI is set to “0”.
See also other documents in the category Abocom Hardware:
- FM560MX (1 page)
- WU5204 (2 pages)
- WR201 (4 pages)
- UCM56CR (16 pages)
- WB1500H (1 page)
- FVR206 (10 pages)
- RE450MX (13 pages)
- X-Disk (1 page)
- Powerline Filter for PLC Communication PLF100 (2 pages)
- UTA128 (1 page)
- FSM612 (1 page)
- WUE1500 (20 pages)
- Internal Fax Modem 56K (19 pages)
- FE2000VX (11 pages)
- WMG2400 (3 pages)
- Wireless USB Adapter WUB1500 (1 page)
- WAP404 (2 pages)
- M73-APO07-300 (2 pages)
- UBT2K1H (2 pages)
- M73-APO0A-010 (15 pages)
- EFM56CC (1 page)
- FE1000SX (1 page)
- CWB1000 (19 pages)
- HomePlug 1.0 Turbo Ethernet Adapter PLE0085 (2 pages)
- UBT1000H (3 pages)
- CAS2047 (1 page)
- GFM560 (14 pages)
- FSM610 (1 page)
- UR3060E (2 pages)
- ECR500 (2 pages)
- FE2500MX (1 page)
- WBA580 (1 page)
- MC-56SVV (1 page)
- UBT3K (2 pages)
- PCMCIA (8 pages)
- 10/100M Fast Ethernet M73-APO08-420 (20 pages)
- AP900 (2 pages)
- UHL2000 (1 page)
- TA128 (1 page)
- VDSL to Ethernet Bridge VE1000 (1 page)
- ISDN TA PCI Card PI128 (1 page)
- Bluetooth Wireless USB Adapter UBT1000 (1 page)
- WB1500SH (1 page)
- ARM904 (3 pages)
- IAM800 (1 page)