AEG 41056VH-MN - Manual (Page 10)

When you connect the appliance to the electrical
supply or in case of a power cut, the Time func-
tion indicator flashes automatically.
To set the current time use " + " or " - " button.
After approximately 5 seconds, the flashing stops
and the display shows the time of day set.
For time change you must not set an automatic
function (Duration or End ) at the same
time.
HOB - DAILY USE
WARNING!
Refer to "Safety information" chapter.
When a cooking zone operates, it hums for a short time. This is typical of all ceramic glass
cooking zones and does not show that the appliance operates incorrectly.
To use the appliance, push the control knob. The control knob comes out.
Heat settings
Control knob Function
0 Off position
1-9
Heat settings
(1 = lowest heat setting; 9= highest heat setting)
1. Turn the control knob to a necessary heat setting.
2. To complete the cooking process, turn the control knob to the “0” position.
Use of the double zone
WARNING!
To set double zone on turn the control knob with the double zone to the right (do not turn
it thought the stop position).
1. Turn the control knob to the right - to position "9".
2. Turn the control knob slowly to symbol until you can hear a click.
At this time the two cooking zones are on.
3. To set necessary heat setting refer to "Heat settings".
Residual heat indicator
The residual heat indicator comes on when a cooking zone is hot.
WARNING!
Risk of burns from residual heat!
10 Hob - Daily Use