Lenovo 3000 C305 All-In-One - Manual (Page 21)

Chapter 5. Using the Setup Utility
19
3. The password dialog box will be displayed. Type the new password, and
press Enter.
4. when prompted to confirm the password, type the password again. If
you type the password correctly, the password will be installed.
To delete a previously set Power-On Password, do the following :
1. From the Security menu, select Set Power-On Password and press
Enter.
2. The password dialog box will be displayed. Enter Current Password and
press Enter. Press Enter in New Password and confirm New Password
dialog. A setup notice will display that changes have been saved.
3. Press Enter to continue.
Using Device
USB Setup When this feature is set to Disable,
the device of USB Setup is
disabled and will not be displayed in
the system configuration.
To set Device, do the following:
1. Start the Setup Utility program (see “Starting the Setup Utility program”
on page 16).
2. From the Setup Utility program menu, select Devices.
3. Select USB Setup.
4. Select Disabled or Enabled and press Enter.
5. Return to the Setup Utility program menu and press F10 to save
configuration changes and exit setup.
Note
If you do not want to save the settings, select Discard changes and
Exit.You can set others such as ATA Drives Setup, Video Setup, Audio
Setup, Network Setup. See the information displayed on the right
side of the screen.