Lenovo B470e Notebook - Manual (Page 68)

Applying labels to the base cover
The new base cover FRU is shipped with a kit containing labels of several kinds.
If the Windows Certificate of Authentication label (COA) b is attached to a part that is replaced, return the
old part with the label attached to the customer, or provide a letter to the customer stating what the label
was originally on the system and what the label part number, serial number, and product key were.
The following labels need to be peeled off from the old base cover, and need to be put on the new base cover.
a Palmrest label h Malaysia SIRIM label
c Rating label I Brazil label or BT label for US/CA/TW
d Wistron label j Brazil Label (WLAN) or WLAN label for US/CA/TW or
Israel label for WLAN
e PRC/MTM label k Indonesia D side label
f VODAFONE label l PPT label
g Indonesia WLAN&BT label
For some models, you need to apply two FCC labels. Check the old base cover; if it has two FCC labels,
apply both to the new base cover.
For the location of each label, refer to the following figure:
b
d
e
i
j
k l
h
f
c
g
1150 LCD front bezel
For access, remove these FRUs in order:
•
“1010 Battery pack” on page 44
• “1020 Dummy card” on page 44
• “1030 Bottom slot cover” on page 45
• “1040 Hard disk drive” on page 45
• “1050 Optical drive” on page 46
• “1060 Memory modules” on page 47
• “1070 PCI Express Mini Card for wireless LAN/WAN” on page 48
• “1080 Keyboard” on page 49
• “1090 Keyboard bezel” on page 51
• “1100 System board assembly” on page 53
• “1110 LCD unit” on page 55
62 Hardware Maintenance Manual