Lenovo S40-40 All-in-One - Manual (Page 50)

45
User Guide
7. Tighten the two screws to secure the monitor stand to the computer. Then, put
the rubber blocks into the holes to protect the screws.
Removing and reattaching the transformer stand
Attention: Do not remove the computer cover or attempt any repairs
before reading the “Important safety information” in the Safety and
Warranty Guide that was included with your computer or in the Hardware
Maintenance Manual (HMM) for the computer. To obtain copies of the
Safety and Warranty Guide or HMM, go to the Support Web site at:
http://support.lenovo.com
This section provides instructions on how to remove and reattach the transformer
stand.
Note: The transformer stand is available only for some models.
To remove and reattach the transformer stand, do the following.
1. Remove all media from the drives and turn off all attached devices.
2. Turn off the computer and disconnect all power cords from electrical outlets.
3. Disconnect all cables attached to the computer.
4. Place a soft, clean towel or cloth on the desk or flat surface. Hold the sides of
your computer and gently lay it down so that the screen is resting on the towel
or cloth and the cover is facing up.