Lenovo ThinkVantage Rescue and Recovery 4.3 (Deployment Guide) User Manual

Page 86

Table 33. \Rescue and Recovery\Settings\Backup (continued)

Policy

Setting

Description

BackupNetwork

Enable or disable Backup Network as a
selected destination for backup. Default:
Disabled.

Notes:

If a service partition backup fails due to
insufficient space, manually delete the
failed backup before making another
backup or attempting to restore from the
failed backup.

When backing up the service partition to
external media, set the following registry
key before restoring your system with the
Rescue and Recovery program:

HKLM\Software\Lenovo\
Rescue and Recovery\
Settings\Backup\
BackupSPNetwork=1

LocalPartitionNumber

Set the partition number for backups on the
local drive. Valid values: 1-100. Default: 1.

USBPartitionNumber

Set the partition number for backups on the
USB drive. Valid values: 1-100. Default: 1.

SecondHDDPartitionNumber

Set the partition number for backups on the
Second hard disk drive. Valid values: 1-100.
Default: 1.

Backup Partitions

Select the partitions that should be backed up.
A DWORD (double word) is a bitmap of
logical drive letters that should be included in
the backup.
To get the right hexadecimal value for drive
letters, lay out the drive letters from right to
left (for example, ...HGFEDCBA), and put 1
for partitions that will be backed up.
Example: If you back up drive C: and E: only,
you will get the binary value 00010100. The
hexadecimal value for it is 0x00000014 and the
decimal value for it is 20.
Note:

Convert your hexadecimal number to

decimal before entering a value. Default:
0xFFFFFFFF. Entering a zero has a meaning
similar to the default, which means finding all
available partitions and back them up.

MaxBackupSize

The maximum backup size (in GB). Valid
values are 1-1000. Default: available free
space.

Rescue and Recovery 4.3 Deployment Guide