Installation locations – Kodak 805 User Manual
Page 16
Introduction
Installation Locations
Maintain good ventilation.
Ventilation slots and holes are provided on the top and rear of this unit.
Place the unit on a hard, level surface. Allow the following minimum space
around the printer to ensure proper ventilation:
Top: 2 in. (5.08 cm)
Sides: 0.5 in. (1.27 cm)
Rear: 2 in. (5.08 cm) - If the rear dust cover is in place (recommended)
then no additional space is required at the rear.
When installing the unit in a system rack, leave space between the unit and
the back of the rack.
Unsuitable locations:
Locations with high humidity and dust:
Do not place the unit in locations with high humidity and dust. They can
cause extensive damage. Avoid locations where the unit is likely to be
exposed to oily fumes and vapors.
Locations likely to be extremely hot:
Locations exposed to direct sunlight or near heating appliances can
attain extremely high temperatures which may deform the cabinet or
cause other damage.