Kodak V600 Zoom - Manual (Page 2)

EASTMAN KODAK COMPANY
Rochester, NY 14650
Kodak is a trademark of Eastman Kodak Company. © Eastman Kodak Company, 2000 Printed in the U.S.A. 3/00
KODAK V600 Digital Projector • KODAK V600 Zoom Digital Projector
with Kodak’s Exlusive Image Manager
Using the Remote Control and Keypad
The remote control and projector keypad perform similar operations, except—the remote control has a volume control.
Projector Safety
Warning: Don’t look directly into the lens when the projector is
turned on. Doing so may cause eye injury.
Warning: To replace the lamp, turn off the power and unplug the
power cord. To avoid burns, wait 30 minutes before opening the
lamp door. Follow all instructions provided in this User Guide. See
“Changing the Lamp Module” on page 23.
Warning: Please use the power cord provided. Connect the power
cord to a receptacle with a protective safety (earth) ground terminal.
Warning: Servicing your own projector may expose you to hazards
or create potential hazards. Also, servicing your own projector will
void the warranty. Refer all service to qualified service personnel.
See “If You Need Assistance” on page 5.
Warning: In the unlikely event of the bulb rupturing, thoroughly
clean the area behind the projector and discard any food that might
have been contaminated with broken glass.
Warning: When replacing the lamp, be sure to turn off the power
and unplug the power cord. To avoid burns, wait 30 minutes before
opening the lamp door.
Warning: When you open the lamp module door, be careful to not
touch the hot surfaces inside.
Warning: Do not loosen or remove any screws other than those on
the lamp module door and the lamp module. Doing so may result
in electric shock.
Caution: Don’t set liquids on the projector. Spilled liquids may
damage your projector.
Caution: Don’t place the projector on a hot surface or in direct
sunlight.
Caution: Do not drop the projector.
Caution: Never operate your projector without the lamp module or
lamp module door. Doing so may damage the projector.
Caution: Don’t block ventilation openings. Never operate this
projector in an enclosed area. Do not place the projector on a
tablecloth or other soft covering that may block the vents. With
ceiling installations, the use of approved mounting hardware is
required. Do not locate the projector near heat ducts, air cleaners,
transformers or other electrical devices. For permanent installations
follow local codes.
Caution: Do not touch the glass portion of the new lamp module
with your hands or allow it to touch other objects as this may damage
it and shorten its operational life.
Caution: Do not drop the lamp module as the glass may shatter
and cause injury.
Turning Off the Projector
1. Press the Power button on the keypad or remote control.
A confirmation screen appears.
2. Press the Power button again to confirm.
The lamp turns off immediately but the fan continues to run until
the projector cools down.
The Power light continues to blink slowly as long as the live power
cord is connected to the projector.
Power—turns the projector on and off
Menu—displays the menus on the projected
image
Enter—selects an option button
Next—highlights the next feature in the menu
Adjust—navigates between tabs; moves a
highlighted slider bar left or right; and moves
between options for features like Source and
Projection
Volume—increases or decreases volume Keypad
Remote Control
(Optional with V600)
Power Menu
Enter Next
Adjust
Volume
POWER
MENU
ADJUST
ENTER
NEXT