Kodak DP850 Ultra - Manual (Page 10)

Contents
10
4. Connecting a video source to the KODAK DP850 ULTRA
The procedure for connecting a video
source to the KODAK DP850 ULTRA is
the same for S-video and Composite
video
SECAM, PAL N and PAL M modes are manually
selected by pressing the “Green Button“. If the right
format is not found the first time, press again. The
video format is stored separately for each connector.
1. Make sure that the video source and the
KODAK DP850 ULTRA are switched off.
2. Connect the video cable from the Video out
connector of the video source to the correct video
connector on the KODAK DP850 ULTRA plug panel.
3. Connect the audio cable from the Audio out
connectors of the video source to the Audio in
connectors on the KODAK DP850 ULTRA. Connect
the red plug to the red connector, and the other
plug to the white connector. Red is the right stereo
channel.
4. When all the connections are done and verified,
switch on the video source and the KODAK DP850
ULTRA.
5. The KODAK DP850 ULTRA will now automatically
display the pictures from the video source. If not,
see the section ‘What do I do if’.
Figure 9: Connecting to video sources
1214 (ELEK). KODAK ENG 05-05-98 11:41 Side 10