Kodak 500 - Manual (Page 54)

48 www.kodak.com/go/support
Troubleshooting
Light is off There is no device connected to
the USB device connector on the
printer. None required.
The connection between the
printer and device is loose. Check the USB connections from the
device to the printer.
A device other than a compatible
Kodak card reader or PictBridge
compatible camera or device is
connected. Disconnect the device. Connect a Kodak
8-in-1 card reader, or a PictBridge
compatible camera or device.
Card slot light (SDIO/memory card behavior)
Light status Cause Action/solution
Light blinks green Slow blink: the internal card
reader is initializing or
communicating with the
printer. None required.
Fast blink: there is a card or
communication error. Remove the card and make sure the
card is not write protected or damaged.
Replace with a new card if necessary.
Reinsert the card.
Light is off An SDIO/SD/MMC card is not
inserted or is improperly
inserted in the card slot. None required.
USB device connector light
Light status Cause Action/solution