Kodak 4600 - Manual (Page 17)

Replacements and Installations
SM5440-1 – 18NOV97 17
[20] Remove the 2 SCREWS from the CYCLE
SOLENOID.
[21] Remove the CYCLE SOLENOID.
[22] Slide the PLUNGER and PLUNGER SPRING off
the CYCLE LEVER.
[23] Remove the HALF CYCLE SPRING between the
CYCLE LEVER ASSEMBLY and the HALF
CYCLE LEVER.
[24] Disconnect the INDEX LEVER SPRING from the
MECHANISM ASSEMBLY.
[25] Push the INDEX LEVER back.
[26] Remove the 2 E-RINGS:
• 1 on the CYCLE LEVER ASSEMBLY
• 1 on the HALF CYCLE LEVER
Caution
Keep both the CYCLE LEVER ASSEMBLY and the
HALF CYCLE LEVER together and observe the
orientation of both LEVERS.
[27] Slide both the CYCLE LEVER and HALF CYCLE
LEVER off the SHAFT.
Installing the CAM STACK ASSEMBLY and CYCLE LEVER ASSEMBLY
Caution
Keep both the CYCLE LEVER ASSEMBLY and the
HALF CYCLE LEVER together and observe the
orientation of both LEVERS.
[1] Do the replacement procedure for the CAM
STACK ASSEMBLY and CYCLE LEVER
ASSEMBLY in reverse order.
A091_0009CA
SCREW (2)
CYCLE
SOLENOID
and SPRING
INDEX LEVER
(not shown)
PLUNGER
LEVER SPRING
HALF-CYCLE
SPRING
PLUNGER
LEVER
CYCLE
LEVER
HALF-CYCLE
A091_0009CCA
E-RING (2)