Acer V.32bis User Manual
Page 12
11
+FLID=n
Local ID string (TSI/CSI)
+FMDL?
Request DCE Model
+FMFR?
Request DCE Manufacturer
+FPPR:
Partial Page Report Response
+FPTS:
Receive Page Transfer Status Response
+FPTS:
Transmit Page Transfer Status Response
+FPTS=n
Page Transfer Status Parameter
+FREV?
Request DCE Revision
3.7
Voice Mode Commands
#VA=m
Enable/disable AGC
#VAA=n
Select auto-answer mode
#VB=f1,t
Generate beep tone(f1=frequency,t=duration)
#VBL=n
Sets voice buffer length control
#VBO=n
Set binary offset mode
#VBS=n
Specify data transfer via DMA
#VC
Disable, Enable
abort
#VCH=n
Set DMA channel
#VDR=e,r
Enable distinctive ring detection
#VD0
Transmit voice data
#VD1
Receive Voice Data
#VF=n
Set FIFO size
#VG=n
Gain setting in voice record mode
#VH=n
Energize relay
#VL
Set run-length encoding
#VM=n
Microphone command
#VNH=n
Set hook behavior for fax and data calls within
voice calls
#VRA=n
Ringback goes away timer
#VRN=n
Ringback never came timer
#VSC=n
Set compression mode to n
#VSD=0,1,2
Silence deletion control (disable, 1 sec, .5 sec.)
#VSI=n
Set silence end of message timer
#VSM=n
Set CODEC mode to n
#VSn
Activate voice mode (DTE rate n)
#VSP=n
Set monitor mode
#VSR=n
Enable actions and/or speakerphone response
codes
#VSS=n
Set sample rate to n
#VST
Set silence threshold -43dBm/-47dBm
#VSV
Transmit voice data, listen for DTMF and
CNG
#VTI=n
Supervision point qualifier
#VTn
Controls command mode DTMF and CNG
detection