Altinex Pop `N Plug PNP350 - Manual (Page 3)

TABLETOP SOLUTIONS
400-0114-004 2
PRECAUTIONS / SAFETY WARNINGS 1
Please read this manual carefully before using your
PNP300/350 and keep it handy for future reference.
These safety instructions are to ensure the long life
of your PNP300/350 and to prevent fire and shock
hazards. Please read them carefully and heed all
warnings.
1.1 GENERAL
•
Do not open the unit or power supply case, there
are high-voltage components inside.
•
There are no user serviceable parts inside.
Qualified ALTINEX service personnel must
perform all service on the Pop ‘N Plug.
1.2 HANDLING
•
For best results, place the PNP300/350 in a dry
area away from dust and moisture.
•
To prevent fire or shock, do not expose this unit
to water
or moisture. Do not place the
PNP300/350 in direct sunlight, near heaters, or
heat-radiating appliances, or near any liquid.
Exposure to direct sunlight, smoke, or steam can
harm internal components.
•
Handle the PNP300/350 carefully. Dropping or
jarring can damage the unit.
•
Do not pull any cables that are attached to the
PNP300/350.
•
Do not place heavy objects on top of the
PNP300/350.
•
Never place fingers inside the openings of the
unit.
•
If the PNP300/350 interface is not used for an
extended period, disconnect the unit from the
wall to avoid fire, shock, and loss of power.
•
We recommend using wall outlets with a Ground
Fault Circuit Interrupter (GFCI) for maximum
protection.
1.3 CLEANING
•
Unplug the PNP300/350 before cleaning.
•
Clean only with a dry cloth. Never use strong
detergents or solvents such as alcohol or
thinner. Do not use a wet cloth or water to clean
the unit. Do not open the unit to clean.
1.4 FCC NOTICE
•
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired
operation.
•
This equipment has been tested and found to
comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference when the
equipment is operated in a commercial
environment. This equipment generates, uses,
and can radiate radio frequency energy and if
not installed and used in accordance with
instructions found herein, may cause harmful
interference to radio communications. Operation
of this equipment in a residential area is likely to
cause harmful interference in which case the
user will be required to correct the interference
at his own expense.
•
Any changes or modifications to the unit not
expressly approved by ALTINEX, Inc. could void
the user’s authority to operate the equipment.