Vollrath Mix60-Water Cooled - Manual (Page 12)

English
Mixer
12
6 D
EVICE
’
S OPERATION
6.1 Warnings
WHEN USING THE DEVICE, AS WITH ALL ELECTRICAL APPARATUS, ESSENTIAL RULES MUST BE
COMPLIED WITH, PARTICULARLY:
- never touch it if your feet or hands are wet;
- never operate it while barefoot;
- never unplug the power cord without first turning off the circuit breaker;
- avoid liquids to penetrate in the device, for example during its cleaning;
- do not allow children or untrained individuals near this device.
In case of failure and/or malfunctioning of the device - and any time you notice damages, especially at the supply cable or
at the safety devices - turn off the circuit breaker and contact a service technician.
NEVER operate the machine when empty or with an amount of mixture other than the one recommended.
The beater is designed to stir liquids, NOT to grind solids.
NOT RESPECTING THESE RULES, IN ADDITION TO VOIDING ANY FORM OF WARRANTY, CAN SERI-
OUSLY COMPROMISE THE SAFETY, PERFORMANCES AND FUNCTIONING OF THE DEVICE.
6.2 Controls and indicators
Z1
K1
Z4
K4
Z7
K7
K8 K9 Z9
K2
K3
Z5
Z6
K5
K6
PS10
All controls and indicators for the use of the device are grouped in a single control
panel placed on the front panel. It functions on low voltage.
In this manual, the buttons and indicators are identified with the relative symbol, and/
or with an imprint ([K…] for pushbuttons, [Z…] for indicators).
The functioning of every control is described below. To obtain the best results, pease
read carefully before operating the device.
ON/OFF Pushbutton [K1]
When the electric supply is connected, the machine is ready to be turned on. The green indicator [Z1] will light. When
pressing [K1], the machine is on, a short electronic test is performed and the other pushbuttons are enabled. The display
shows the temperature inside the tank, in °C.
ADJUSTMENT Pushbuttons [K2] - [K3]
These pushbuttons are enabled only after pressing SET UP [K8]. They increase or decrease set values. For more details
on their use, see Par. 6. 3 “Setting Up”.
FAST BEATING button [K4]
On pressing the button, the relative [Z4] light comes on and the beater works CONTINUOUSLY AT HIGH SPEED. This
command can also be inserted during the heating/cooling and preservation cycle. When the button is pressed again, the
beater stops and the light turns off.