beautypg.com

English, Warning – Vollrath Refrigerated Frost-Top User Manual

Page 3

background image

F

abricator

c

omponents

3

ENGLISH

O

peratOr

s

M

anual

o

peration

WARNING

Electrical Shock Hazard.

Keep water and other liquids from entering the

inside of the unit. Liquid inside the unit could cause

an electrical shock. Do not damaged power cord.

Do not over fill wells, pans or trays. Liquid could contact the

electrical components and cause a short circuit or an electrical

shock. Unplug unit before performing service, draining or removing

spillage pans and trays. Do not spray water or cleaning products.

Do not use a power cord that has been modified or damaged.

1. Check the drain valve (A) to verify it is in the CLOSED position to prevent

water from draining out. See Figure 1. The valve is in the CLOSED

position when the handle of the valve forms a “T” with the body of the

valve.

2. Plug the equipment into a properly grounded electrical supply matching

the nameplate rating. Damage to the equipment can occur if incorrect

power is supplied to equipment.

3. Turn the power switch (B) to the “ON” position. This unit does not have

an adjustable temperature setting. Allow the unit to run for approximately

30 minutes. For the best performance when using ice with this unit, allow

unit to run for approximately 2 hours before adding ice. This will help the

ice remain solid.

4. Place containers of properly chilled food onto the pre-chilled unit.
5. Regularly check the food temperature.
NOTE:

Monitor food temperature closely for food safety. The United States

Public Health Service recommends that hot food be held at a maximum

of 41 ºF (5 ºC) to help prevent bacteria growth.
6. When finished using the unit turn the power switch (B) to the “OFF”

position. Remove the food containers.

7. Place a suitable container directly under the drain valve (A) Open the

drain valve and drain the water. The valve is in the OPEN position when

the handle of the valve is aligned with the body of the valve.

8. Close the drain valve (A). Rotate the valve to the CLOSED position,

when the handle of the valve forms a “T” with the body of the valve.

c

leaning

To maintain the appearance and increase the service life, clean your

equipment daily.
NOTE:

Do not use caustic cleaning chemicals, steel wool or

commercial lime removal products to clean the equipment.

Thoroughly rinse equipment with water after cleaning.

WARNING

Electrical Shock Hazard.

Keep water and other liquids from entering the

inside of the unit. Liquid inside the unit could cause

an electrical shock. Do not damaged power cord.

Do not over fill wells, pans or trays. Liquid could contact the

electrical components and cause a short circuit or an electrical

shock. Unplug unit before performing service, draining or removing

spillage pans and trays. Do not spray water or cleaning products.

Do not use a power cord that has been modified or damaged.

9. When finished using the unit turn the power switch (B) to the “OFF”

position. Remove the food containers.

10. Open the drain valve (A) and drain the water. The valve is in the OPEN

position when the handle of the valve is aligned with the body of the

valve.

11. Using a damp cloth, sponge dipped in soapy water to clean the inside of

the well and the outside of the equipment.

12. Close the drain valve (A). Rotate the valve to the CLOSED position,

when the handle of the valve forms a “T” with the body of the valve.

t

roUbleShooting

c

hart

Problem

It might be caused by

Course of Action

Unit does not get to correct temperature.

Unit is not plugged in.

Plug unit in.

Compressor defective.

Have the compressor replaced.

S

ervice

and

r

epair

There are no user serviceable parts within this appliance. To avoid serious injury or damage, never attempt to repair the equipment or replace a damaged power

cord yourself. Do not send equipment directly to the Vollrath Company. Please contact the qualified professional repair service listed below.

VOLLRATH Technical Service • 1-800-628-0832

c

UtoUt

d

imenSionS

c

hart

d

rop

-i

nS

F

roSt

t

op

CUTOUT dimensions given in inches and (cm).

Item

Cutout Dimensions

36419

25-1/4 x 27-1/2 (64.1 x 69.8)

36420

25-1/4 x 40-3/4 (64.1 x 103.5)

36424

25-1/4 x 54 (64.1 x 137.1)

36426

25-1/4 x 67-1/4 (64.1 x 170.8)

36428

25-1/4 x 80-1/2 (64.1 x 204.4)