Start – Vogels PFW 6875 User Manual

Page 8

PFW 6875

Page 8

Installation Instructions

Installing OPTIONAL Model Specific Spacers

PFW 6875 dedicated flat-panel spacers are engineered with

the knowledge that aligning each flat-panel on a large wall is

time consuming and costly.

These model-specific spacers

are available for most flat-panels, which significantly reduces

the installation time.

This spacer is shown for illustration purposes only.

Your spacer may look different depending on the

display model you are installing.

1) Once your PFW 6875 is mounted in the desired

location and is level, align your spacer to the top left

or right (depending on your install direction) corner

You may use commercially available hardware to

secure the spacer to the wall during installation

(depending on the wall material). You may utilize the

same spacer for multiple PFW 6875 installations.

Step 1

Multiple PFW 6875 mounts can be installed using model specific spacers. Simply repeat step one when installing

each of the surrounding PFW 6875 mounts. Use one spacer for each 2x2 installation by mounting it to the wall, or

utilize the same spacer as many times needed to complete an unlimited PFW 6875 large matrix video wall.
1. Make sure the spacer is plumb and level and mark each corner where the PFW 6875 will be mounted (or

secure to the wall). It is best to start from the bottom corner and work your way up.

2. Install the second mount working in a horizontal direction.
3. Ensure that the mount remains plumb and level.
4. Repeat this step for each mount horizontally
5. To install multiple rows, place spacer between previously installed PFW 6875 on the bottom row. Make sure the

spacer is plumb and level, mark the corners (or secure to the wall) to be sure of where the PFW 6875 should be

and secure your mount to the wall.

Step 2

Register Tabs

Start