Silent Call SU5001-V - Manual (Page 2)

5095 Williams Lake Road, Waterford Michigan 48329
(800) 572-5227
http://www.silentcall.com
To program a new code:
1. Press the program button. Both LEDs will illuminate. Hold the program button until the LEDs go out
(about 8 seconds). Release the button and the Shakeup receiver is in program mode. It will remain in
program mode for approximately 30 seconds. While in program mode, it will memorize the code of
the first transmitter it receives and then exit program mode.
2. While the Shakeup receiver is in program mode, press the button on any Silent Call transmitter that has
been set to the desired system code. When the Shakeup receiver receives the transmitter, it will
memorize the code and exit program mode. The Shakeup receiver can memorize an unlimited number
of system codes.
3. Note that you do not have to program the Shakeup receiver with every transmitter in your system as
long as all transmitters are set to the same code.
4. Programmed codes are retained in memory even when the Shakeup power is removed.
Technical Support
For technical support on this or any other Silent Call product, please feel free to contact us. You can reach
us by phone at 800-572-5227 (voice or TTY) or by Email at
[email protected]
Limited Warranty
Your Shakeup Receiver is warranted to be free of defects in material and workmanship for five years from
the date of initial purchase (one year for the strobe and/or vibrator). During that time, the unit will be
repaired or replaced free of charge when shipped prepaid to Silent Call Communications.
This warranty is void if the defect is caused by customer abuse or neglect.
Rev 2