beautypg.com

En g li s h – Nostalgia Electrics MDF200 User Manual

Page 12

background image

E

N

G

LI

S

H

10

11. Reassemble your AUTOMATIC MINI DONUT FACTORY.

By following these simple instructions, your AUTOMATIC MINI DONUT FACTORY

will be a fun and special treat for your family, friends and kids of all ages!

To prolong the life of your AUTOMATIC MINI DONUT FACTORY, be sure to

follow the cleaning instructions above after each and every use.

BREAKDOWN OF DOUGH DISPENSER FOR CLEANING:

1.

Put your finger on the plunger as you turn the donut hopper over. You should

notice the Dough Release is extended. Unscrew this part. See illustration below.

2.

Using your thumb and first finger, firmly pull up on

one end of the ‘wings’, releasing it from the outer edge.

Now, release the second ‘wing’ the same way.

3.

Now you can remove the plunger and stem assembly.

4.

Turn the Dough Dispenser over and press in to release inside piece from inside mixer.

5.

You should now have all four parts to the Dough Dispenser released for cleaning. Wash

in warm, soapy water. You may need to push the plunger down exposing the lower

threaded stem and confirm that the stem portion above the threads is clean and smooth.

6.

Reassemble after cleaning and drying.

Plunger

Outer

Edge

Wing

Dough Release

NOTE: You may find it

necessary to use a small, fine

brush to clean the hardened

and caked donut batter

from cracks, crevices and the

spring on the trigger stem.