MyWeigh HD SERIES - Manual (Page 2)

My Weigh HD Series Scales Manual
Thank you for purchasing the My Weigh HD Series parcel scale. This scale is designed to provide years of
accurate weighing. Please read this entire manual before use. If you have any questions about your scale or
have troubleshooting concerns, please visit our website at www.MyWeigh.com.
**Batteries and AC Adaptor:
The HD Series scale was designed to run with AC power (ac adapter included) or optional AA batteries. The AC
adaptor plugs into the hole on the back side of the scales weighing indicator. If you want to use batteries, please
install them in the battery compartment on the underside of the base of the scale.
For battery installation, turn over the scale, you’ll see the battery compartment on the underside of the base of
the scale , lift and open (see the enclosed drawing Fig1) the battery cover, remove and/or install the batteries. Be
sure that the batteries are installed correctly following the polarity indicators in the battery compartment. Reinstall
the battery cover..
Only operate the scale on a flat, level surface that is stable and durable enough to support the scale and the
items being placed on the scale. Either place the remote display box together with the scale on its surface or
mount the display box on a wall at a suitable height with the included wall mounting kit.
This HD Series scale is compatible with most UPS and other shipping software through the built-in RS-232 port.
Please contact your software vendor for all computer hookup, operation and installation related questions. More
information regarding RS-232 connectivity can be found in the Advanced Operating Instructions within Section 4
of this manual.
Notice：
1).Press [ON/OFF] key to turn on the sacle.
2). Press and hold [ON/OFF] for 3 seconds to turn off the scale.
1. Specifications
Model HD150 HD300
Capacity 60kg/150lb 120kg/300lb
Graduation 0.02kg/0.05lb 0.05kg/0.1lb
2. How to Program the Auto-off time:
(1) Press down the “D” key until the indicator displays “A.OFF.X” (X=0.1.2.3.4.5.6.7.8.9 minutes), the
display value “X” is the auto-off time, when the “X” value is “0”, the auto-off function is disabled.
NOTE: The default factory setting is X=0
(2) To change the auto-off time press the “M” or “D” key; the X value will increase or decrease by 1,
press the “T” key to confirm the auto-off time setting.
(3) To exit the auto-off timer programming, press the ⊙ key, the display will then reset.
3. Weighing Operation
Press the ⊙ key, the display will show “150.00lb” for the HD150 shipping scale and “300.0lb” for the
HD300 shipping scale. The display will then read ”0.00”. The scale is now ready for use. To begin
weighing, follow these steps:
(1) Press and release the ⊙ key, the scale is now set at its zero point. If you press and hold the key,
then the scale will be turned off.
(2) Press the “M” key to change the weighing unit between “lb” and “kg”.